Hi
Got my new Pluto II board (I am new to FPGA).
I had connected the board to the PC with DS275 (like MAX232) for the Tx line and direct for the Rx line.
Using the FPGA configurator I am able to configure the FPGA but not the PROM.
When I try to configure the PROM I get this massage:
"Result: No boot-PROM found"
Any ideas?
Avi
Pluto II boot PROM configuration challenge
2 posts
• Page 1 of 1
Pluto II boot PROM configuration challenge
by avic » Sat Jun 16, 2007 3:08 pm
- avic
- Posts: 2
- Joined: Sat Jun 16, 2007 2:54 pm
- Location: Israel
by fpga4fun » Sat Jun 16, 2007 9:06 pm
It can be two things:
1. The communication with the board doesn't work properly. Try to get the SerialRx and SerialRxTx projects working. Then try again the boot-PROM.
2. The frequency in FPGAconf isn't set correctly. Check Options/Pluto-II clock speed.
1. The communication with the board doesn't work properly. Try to get the SerialRx and SerialRxTx projects working. Then try again the boot-PROM.
2. The frequency in FPGAconf isn't set correctly. Check Options/Pluto-II clock speed.
- fpga4fun
- Site Admin
- Posts: 837
- Joined: Thu Sep 18, 2003 6:47 am
2 posts
• Page 1 of 1